DOTLUX 5274 Mode D'emploi page 14

System parameter setting
- Long press M and key in the same time for 2s, prepare for setup system parameter:
decode mode, output PWM frequence, output brightness curve, automatic blank screen.
short press M key to switch four item.
- Decode mode: short press or key to switch 1/2/4 channel decode mode(„d-
1","d-2" or „d-4"). When set as 1 channel decode, the decoder occupy only 1 DMX address,
and four channel output the same brightness of this DMX address.
- Output PWM frequence: short press or key to switch 500Hz(„F-L") or 2KHz(„F-H").
- Output brightness curve: short press or key to switch linear curve(„C-L") or loga-
rithmic curve(„C-E").
- Automatic blank screen: short press or key to switch enable („bon") or disable
(„boF") automatic blank screen.
- Long press M key for 2s or timeout 10s, quit system parameter setting.
DMX mode
- Short press M key, when display 001~999, enter DMX mode- Mit den Pfeiltasten lässt
sich ganz einfach die DMX-Startadresse einstellen.
- Press or key to change DMX decode start address(001~999),
long press for fast adjustment
- If there is a DMX signal input, will enter DMX mode automatically.
- DMX Dimming: Each 5274 / 5275 DMX decoder occupy 4 DMX address
when connecting the DMX console.
For example, the defaulted start address is 1,
their corresponding relationship in the form:
14