Kobalt SGY-AIR160NB Mode D'emploi page 17

OPERATING INSTRUCTIONS
6. Trigger the gun properly. Start the gun
moving at the beginning of the stroke
before squeezing the trigger (J1/J2) and
release the trigger (J1/J2) before stopping
gun movement at the end of stroke. This
procedure will feather/blend each stroke
with the next without showing overlap or
unevenness. (See Figure 7)
NOTE The amount of paint being applied
can be varied by the speed of stroke,
distance from workpiece and adjustment
of fluid adjustment knob (G1/G2). If speed
of stroke is too slow, paint will be wet on
workpiece and may run. If speed of stroke
is too fast, paint will be dry and uneven on
workpiece.
7. Overlap strokes just enough to obtain an
even and fine coat (See Figure 8).
NOTE Two thin coats of paint will yield better
spraying results and have less chance of
runs than one heavy layer.
8. Use a piece of cardboard as a shield to
catch overspray at the edges of workpiece
to protect other surfaces. Use masking
tape (not included) to cover other areas if
needed.
7
6 - 9 in.
8
17