Installing The Seat - Axkid Kidzone Mode D'emploi

Placing Your Child In The Seat
Press the harness adjuster button (I) and pull forward on the shoulder straps (not the shoulder pads) to
17
completely loosen the harness.
18 Press the red harness release button on the buckle and unfasten the harness.
Place your child in the car seat. Put your child' s arms in between the shoulder straps so that the
19
straps are hanging over the chest and stomach.
20
Pull the shoulder straps together and insert the harness tongues into the crotch buckle.
Pull the harness adjustment strap (J). It' s important that you always pull the harness straight and
21
central when you tighten the adjustment strap. This will tighten the harness and the headrest
will automatically slide down to the appropriate height.
Head Support Brake On Headrest
The headrest on your Kidzone is equipped with a head support brake. This can be used if
22
you want to keep the headrest in a fixed position. To activate the head support brake, pull the
harness adjustment strap until the headrest is at the desired height, you will hear a faint "click"
sound from the headrest as it locks into position. Check that the headrest can not be pulled down any
further and activate the headrest brake by moving the lever (i) across to the right.
WARNING: Do not pull up the headrest with the parking brake activated.
Forward-Facing 9-18 Kg With Seat Belt

Installing The Seat

Make sure the seat' s angle is in position (i). If not, press the adjustment lever (K) and tilt the seat
23
forward until it stands straight up.
Place your Kidzone on the car seat. Unzip the seat cover where the top belt guides are (A).
24
Screw open the nut on the top belt guide. Pull the car' s seat belt and place the shoulder strap
into the top belt guide (A) on the upper side of the seat and close the nut.
Pull the seat belt straight vertically down, on the backside, to the nearest hole in the back of the
25
seat.
Feed the car' s lap belt and shoulder belt through the first hole, across the front of the chair
26
between the seat cover and the seat body and then back through the second hole.
Pull both belts horizontally across chair and fasten the seat belt in the belt buckle.
27
8