Placing The Seat In The Vehicle - Axkid Kidzone Mode D'emploi

Rear-Facing 9-25 Kg With Seat Belt & Tethers

Placing The Seat In The Vehicle

The easiest way to lift the Kidzone into the vehicle is with its back first. Place the child restraint in
2
the vehicle with the back of the restraint facing the front of the vehicle.
The heels (U) should be sitting over the edge of the vehicle seat. The indented vertical line (P)
3
on the heel should align vertically with the end of the vehicle' s seat. If installing in a small vehicle,
or if your child does not require extra leg room, you can instead place the heel upon the vehicle' s
seat this will also achieve a more reclined position.
Note: When installing Kidzone in the front seat it is possible, but not crucial, for the back of the
restraint to have contact with the dashboard.
To adjust the angle of the child restraint, press the recline adjustment lever (K) to select one of
4
the three reclining positions. Always choose the most upright position as possible, however
your child must be able to hold their head up on its own, and there should be enough recline
to ensure your child' s head does not fall forward when sleeping. The rule of thumb is that the older
the child grows, the more upright the seat can be installed. Please note that once the installation
of the Kidzone is complete, it will be somewhat more reclined as it sinks into the vehicle' s seat from
tightening seat belts and tether straps.
Fastening The Vehicle Seat Belt
Open the belt lock-off clips (M) on both sides of the Kidzone child restraint. Fully lengthen the
5
seat belt until the lap section of the belt is at least 70-80cm (27-32 inches) long. Feed the seat
belt through the seat belt slot (H), between the seat cover and seat body until the belt comes
out through the seat belt slot on the other side. If you prefer, you can instead feed the seat belt through
the seat belt slot (H), then over the top of the seat belt cover and then through the seat belt slot on the
other side.
Insert the seat belt tongue into the vehicle' s seat belt buckle. Pull the seat belt until all slack is
6
removed along the seat belt route. Secure both the lap and shoulder belt in the lock-off closest
to the vehicle' s seat belt buckle.
7
In the lock-off on the opposite side, only the lap belt should be secured.
6