Valor 1130FFK Guide D'installation page 4

Finish kit installation
Once the appliance installation is completed with gas
supply connected, liners, fuel bed and window installed,
aeration checked, remote control paired and wall finish
completed, finish the installation of the framing kit.
1. Slide the removable panel in the clip on the
horizontal supports on each side and push it in until
flush with the front trim.
2. Identify left hand door from right using diagram
below.
LH Door
finger grip inboard,
with locator on left
4
RH Door
finger grip inboard,
with locator on right
3. Position LH door to left side of front frame, identify
door slots top and bottom just behind front panel
and slide door locator in position.
4. Repeat for other door.
5. Install the barrier screen. The tabs rest at the
bottom and the screen is held in place by magnets.
a. Rest the bottom tabs on the edge of the
removable cover as indicated.
b. Push the screen against the steel front panel.
b
a
a
tabs at the
bottom