Installing Stainless Steel Handle - Avanti COR30W3S Manuel D'instructions

REVERSING THE DOOR SWING OF YOUR REFRIGERATOR
This unit has the capability of the doors opening from either the left or right side. The unit is delivered to
you with the doors opening from the left side. Should you desire to reverse the opening direction, please
call service for reversal instructions.
 INSTALLING STAINLESS STEEL HANDLE
This unit includes a stainless steel handle that is not required to operate this unit. To
install the handle please follow the below instructions:
1. Pull away the door gasket in the area where the handle is to be installed as
shown below in Illustration # 1. The gasket is easily displaced by hand, no
tools are necessary.
2. Align the handle with the screws pre-installed on the backside of the door.
Tighten the screws using a Phillips head screwdriver until the handle sets
both flush and secured tightly against the door frame. (DO NOT overtighten
as this will cause damage to the handle assembly).
3. Replace the door gasket to its original position.
 WHEELS:
1. Remove the pre-installed feet.
2. Screw in the front 2 wheels by hand as shown below.
3. Screw in the back 2 wheels with screws as shown below.
1 Gasket 2 Screwdriver 3 Handle
8