Reversing The Door Swing Of Your Refrigerator; Installing Stainless Steel Handle; Door Lock; Caster Installation - Avanti OR51Z3SSN Manuel D'instructions

REVERSING THE DOOR SWING OF YOUR REFRIGERATOR

This refrigerator-freezer has the capability of the doors opening from either the left or right side. The
unit is delivered to you with the doors opening from the left side. Should you desire to reverse the
opening direction, please call service for reversal instructions.

INSTALLING STAINLESS STEEL HANDLE

This appliance includes a stainless-steel handle that is not
required to operate this unit.
To install the handle please follow the below instructions:
1. Pull away the door gasket in the area where the handle
is to be installed as shown in Illustration. The gasket is
easily displaced by hand, no tools are necessary.
2. Locate the screws included in the bag with the user's
guide. Insert the screws into the holes as shown.
3. Align the handle with the screws installed. Tighten the
screws using a Phillips head screwdriver until the
handle sets both flush and secured tightly against the
door frame. (DO NOT over tighten as this will cause
damage to the handle assembly).
4. Replace the door gasket to its original position.

DOOR LOCK

Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the User's Guide. Insert the key into the lock
and turn it counterclockwise to unlock the door. To lock the door do the reverse operation making
sure metal pin is engaged completely. Remove the key and place it in a secure place for safekeeping.

CASTER INSTALLATION

1) Remove everything from inside the cabinet and lay the unit on a clean, dry, and padded
surface.
2) Install the casters into the holes on the bottom of the unit and tighten with a Phillips head
screwdriver.
3) The (2) two casters equipped with brakes / locks should be installed on the front of the unit.
4) Once all four casters are installed, carefully return the unit to the upright position.
5) Allow the unit to sit in the upright position for 8 – 10 hours to allow the refrigerant to settle
before plugging in and turning the unit on.
9