Truma AquaGo Serie Mode D'emploi page 9

2. Slide the contact sockets (see Figure 5) into
the socket housing (openings 1 and 11) until
they lock in place. You do not have to bother
about the plus and minus poles.
3. After installation, lightly pull the adapter
cable to make sure that the contact sockets
are locked in place.
4. You must attach the socket housing to the
control unit again when you have removed
it. It must lock in place.
5. Lay the adapter cable and fix it in place with
the 2 cable ties, as shown in Figure 5.
6. Connect the connection cable to the adapter
cable (see Figure 5).
Connector X1
Fig. 5
7. Installation is complete.
Lock
Connector X2
Lug
1
Contact socket
Adapter cable
Cable tie
9