Truma AquaGo Serie Mode D'emploi page 17

10. If you now want to decalcify the
Truma AquaGo™ instant water heater,
the removal of the electric antifreeze kit is
complete.
You can find more information about
decalcification in the operating instructions
for the Truma AquaGo™ instant water heater in
"Decalcification (models with control panel)".
11. Inspect the O-rings on the water inlet filter
for cracks. Replace the water inlet filter if
there are cracks.
12. Danger of crushing/pinch-
ing of fingers when the Easy Drain Lever
is closed!
• Never put fingers between Easy Drain
Lever and water inlet filter or latch.
If during installation, it is difficult to in-
stall the heating cartridge, use a small
amount of soap on the O-rings. Never use
grease, because the O-rings are not resis-
tant to grease.
13. Install the water inlet filter as shown in
Fig. 11b. Observe the correct installation
position and close the Easy Drain Lever until
it is locked by the latch.
You can hear a "clicking" sound as the
Easy Drain Lever engages.
14. Insert and close the access door.
15. Removal of the electric antifreeze kit is
complete. You can find information about
operation of the Truma AquaGo™ instant
water heater in "Operating procedures"
in the operating instructions for the
Truma AquaGo™ instant water heater.
17