HoMedics MCS-757HJ Manuel D'instructions page 4

INSTRUCTIONS FOR USE
The cushion comes with a screw located on the back of the unit to protect the massage mechanism
during shipment, which must be removed before the first use to allow the unit to function properly.
Use the provided Allen wrench. Then, properly dispose of the screw.
WARNING: Failure to remove screw may cause permanent damage to the massage cushion.
DO NOT REINSTALL SCREW.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug in any way.
1. Untie cord strap, extend cord, and insert plug into 120-volt household electrical outlet to
power unit.
2. Attach the cushion to most chairs for a luxurious massage as you read, rest, or even work.
See pages 8-9 for instructions on the use of the hand control.
NOTE: The hand control comes with a clear, plastic film to protect the buttons before use. When you
are ready to use your massage cushion, peel off the plastic film by lifting at one corner and pulling
gently. Discard film.
CAUTION: To avoid pinching, do not lean on the back massage mechanism in the cushion when
adjusting your body position.
DO NOT jam or force any part of your body in the moving massage mechanism.
NOTE: This unit is equipped with a 15-minute auto-off feature for your safety.
4