Resol HE-Check Manuel page 15

4/6 Generating the 0-10 V output signal
4/6
0-10V 0%
generated 0-10 V signal in %
OUT 0,0V
generated voltage in V
Signal OFF
signal on / off
Î In order to adjust the duty cycle of the 0-10 V signal,
select the desired value using buttons ♉ and ♊. The
adjusted value will be saved automatically.
The voltage of the 0-10 V signal generated automatically
adapts to the duty cycle value.
Î In order to switch the signal on or off, press button ♟.
5/6 Measuring and generating a PWM signal
(for bidirectional pumps)
5/6
generated PWM signal in %
PWM OUT 100%
signal on / off
Signal OFF
PWM IN 60%
measured PWM signal in %
Flow rate: 1000 l/h
pump feedback (if available)**
Î In order to adjust the duty cycle of the PWM signal,
select the desired value using buttons ♉ and ♊. The
adjusted value will be saved automatically .
Î In order to switch the pump on or off, press button ♟.
** Adjust the pump type by means of the parameter Feed-
back in the 6/6 menu, for correct pump feedback.
6/6 Settings
touch-tone on / off
6/6
SETUP
adjust display brightness
Beep OFF
LCD 50%
adjust PWM frequency
PWM 1000 Hz
Feedback none
adjust pump type
Î In order to scroll through the menu, press button ♟.
The menu line selected is highlighted.
Î In order to carry out adjustments, select the menu line
and adjust the values with the buttons ♉ and ♊. The
adjusted values will be saved automatically.
Adjustment
Adjustment range / selection
channel / menu
2/6
PWM 0 ... 100 %
Signal ON, OFF
4/6
0-10 V 0 ... 100 %
Signal ON, OFF
5/6
PWM OUT 0 ... 100 %
Signal ON, OFF
6/6
Beep ON, OFF
LCD 0 ... 100 %
PWM 40 ... 2000 Hz
Feedback Wilo, Grundfos, none
Factory
setting
100 %
OFF
0 %
OFF
100 %
OFF
OFF
50 %
1000 Hz
none
15