Yakima PowderHound Instructions De Montage page 5

Remove base screw at
hinged-end of carriers.
ATTACH SKILIFT TO
UNIVERSAL MOUNT.
• Use button head screw.
• Tighten with hex wrench.
TIGHTEN FRONT BASE SCREWS.
Tighten any loose bail
screws to secure the
brackets to the crossbars.
CLOSE CARRIERS WITH
FIRM PRESSURE.
1033546D-5/18
Loosen front base screw,
but do not remove the
screw.
ATTACH SKILIFT TO CARRIER.
• Attach hex bolt and hex key, then tighten.
• Loosen any bail screws to reposition
VERIFY THE CLOSURE!
• Pull upward on upper section of
carrier to see if the carrier can open.
• If it opens, apply more pressure when
closing the carrier.
LIFT HINGED SIDE OF
CARRIER
Reinstall base screw into mounting
hardware.
mounting brackets for better fit.