Blackout Function; After Use - IMG STAGELINE LED-4MC Mode D'emploi

4) Press the button COL (11) [repeatedly] to change
the colour or colour combination of the sequence
pattern selected.
5) Press the button TAP (10) to select the type of
sequence control:
button pressed once:
the scenes of the sequence pattern selected will
change by music pulses of sufficient volume via the
microphone (9), the LED "S2L" will light up
button pressed twice (do not wait for more than
one second before pressing the button again):
the scenes of the sequence pattern selected will
change automatically approx. every 3 seconds, the
LED "S2L" will not light up
button pressed four times (or more often, do not
wait for more than one second before pressing the
button again):
the scenes of the sequence pattern selected will
change automatically at the average time between
pressing the button, the LED "S2L" will not light up
6) Define the change of scene with the button TRAN-
SITION (6). The LEDs will indicate the current set-
ting:
"HARD" = sudden change
"SOFT" = transition
Note: For control via microphone, this setting will
not have any effect; there will always be a sudden
change in this case.
5.3 Selecting the total brightness
The button DIMMER (5) will define the total brightness.
Press it repeatedly to switch the brightness between
"50 %", "75 %" and "100 %". The three LEDs will indi-
cate the current setting.
5.4 Stroboscope function
1) If the function B / O is active [the LED below the but-
ton (12) will light up], deactivate it with the button.
2) To activate the stroboscope function, press the but-
ton STROBE (13). The LED "ON" will light up.
Regardless of the setting with the button DIMMER
(5), the spotlights will always flash at maximum
brightness (flash frequency: 16 Hz approx.).
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
3) To deactivate this function, press the button
STROBE once again. The LED "ON" will be extin-
guished.
Note: The stroboscope function will not be created in
the controller; the individual stroboscope function of
each spotlight will be activated via the output of a par-
ticular DMX value in the fourth channel of the spotlight.
If a spotlight is not provided with a corresponding func-
tion, no stroboscope effect will be possible.

5.5 Blackout function

With the blackout function, a temporary blackout of all
spotlights will be possible.
1) To activate the blackout function, press the button
B / O (12). A blackout of all spotlights will result and
the LED below the button will light up.
2) To deactivate the function, press the button once
again. The LED will be extinguished and the con-
troller will return to the previous operating mode.
It will also be possible to select another operating
mode during the blackout function. This mode will be
activated after deactivating the blackout function.

5.6 After use

Switch off the controller with the switch ON / OFF (4). If
the controller is not used for a longer period, discon-
nect the plug-in power supply unit from the mains
socket to prevent unnecessary power consumption.
6 Specifications
Power supply: . . . . . . 12 V
DMX channels: . . . . . 16
Dimensions: . . . . . . . . 71 mm × 35 mm × 113 mm
Weight: . . . . . . . . . . . 310 g
Subject to technical modification.
via plug-in
/100 mA
power supply unit provided
and connected to
100 – 240 V~/50 – 60 Hz
GB
9