Installing Hardware; Loading The Slides Into The Magazine - Braun SlideScan 6000 Mode D'emploi

insTAlling sOFTWARE AnD DRiVER
for Mac (OSX) User
Before installing the scanner driver...
if you choose to use the provided application for image editing, install the applica-
tion software (ex: adobe® Photoshop® elements) by inserting the application Cd
into the computer's Cd/dVd drive. Follow the instructions that will be displayed in a
window that opens automatically.
installing scanner Driver
a. insert insert driver Cd into the computer Cd/dVd drive and explore the
contents.
b. double click the "CyberView X 5.0" icon to begin the installation process. Fol-
low the onscreen prompts to complete the installation process.
nOTE:
make sure the scanner is not connected to the computer during the CyberView
X 5.0 driver installation.
c. restart computer once the installation process is complete.

installing hardware

a. Connect the slide scanner to a power source.
1. locate the power switch on the lower left side of the scanner. make sure
the scanner is turned oFF.
2. Plug the aC adapter into an aC power source First before plugging it
into the scanner.
3. attach the usB cable to the computer using the stadard usB adapter end.
attach the usB adapter end of the cable to back panel of the scanner.
b. ensure the scanner does not have a slide magazine loaded, turn the scanner
on. the calibration cycle on the scanner will start automatically and will take
several minutes to complete. a green light will flash while the calibration is in
progress. the slide transport arm will move in and out of the scanner. make
sure tHere is enouGH room in Front oF tHe sCanner For tHe slide
transPort arm to eXtend FullY, do not PusH tHe arm BaCk durinG
CaliBration.
8
loading slide(s) into the magazine
general Recommendations:
Cardboard based slides should be used with the universal magazine din 108.
•
• Glass framed slides that are attached to glass frames may cause complica-
tions due to the hard edges.
Compact Magazine
a. as illustrated below, turn the magazine with the embossed lettering "Com-
PaCt maGaZine 50" and the white strip on the right facing towards the top.
b. Hold the slide right side up, facing forward so the image is not reversed.
rotate the slide as illustrated and insert each slide, one at a time, into the
magazine.
Warning
: load slides into the magazine properly and make sure the slide mounts are in good
condition. improperly inserted slides or slides with distorted/damaged slide mounts may cause
the scanner to jam and potentially damage both the slide and the scanner.
Compact Magazine
Lettering
White Strip
9