Jensen 142NG Manuel Du Propriétaire page 8

ASSEMBLY INSTRUCTIONS
4.) Connecting the Socket
Coat the gas supply pipe nipple with gas approved pipe compound or tape. Screw
the quick connect socket included with your fire table onto the gas supply pipe.
The quick disconnect should not be permanently attached to the gas hose on the fire
table. The direction of the gas flow is indicated on the socket.
Professionally installed shut-off
valve on the gas supply line
Screw the provided quick connect
socket onto the gas supply pipe
Apply gas approved, pipe
compound or tape
5.) Using the Quick Connect Socket
Using one hand, pull back the sleeve on the quick connect socket and, with the other
hand, insert the unattached end of the fire table gas hose into the socket. Release the
sleeve and continue pushing the hose into the socket until the sleeve snaps into the
locked position.
After making the connection, perform a leak check as described on the next page.
From Fire
Table
8