Ec Declaration Of Conformity; Operational Description - DeVilbiss TEKNA Pro Lite PRO-470 Fiche Technique

Technical Bulletin
TEKNA Pro Lite Gravity Feed Spray Gun
IMPORTANT: Read and follow all instructions and Safety Precautions before using this equipment.
Keep for future use.

EC Declaration of Conformity

We, Finishing Brands UK, Ltd., Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the manufacturer of the
Spray gun model TEKNA PRO LITE, declare, under our sole responsibility, that the equipment to which this
document relates is in conformity with the following standards or other normative documents:
BS EN 12100 PARTS 1 & 2: 2010, BS EN 1953: 1998+A1:2009; and thereby conform to the
protection requirements of Council Directive 98/37/EEC relating to Machinery Safety Directive, and;
EN 13463-1:2009, council Directive 94/9/EC relating to Equipment and Protective Systems
intended for use in Potentially Explosive Atmospheres protection level II 2 G X.
This product also complies with the requirements of the EPA guidelines, PG6/34. Transfer efficiency
certificates are available on request.
The TEKNA Pro Lite Gravity Feed Spray Gun Kit complies to ATEX regulations 94/9/EC, protection level II 2 G X,
Suitable for use in Zones 1 and 2.
DeVilbiss Automotive Refinishing reserve the right to modify equipment specification without prior notice.

Operational Description

The TEKNA spray gun is a lightweight professional gun designed to handle both water-based and
Pro Lite
solvent-based coating materials. Both HVLP and high efficiency models are available.
High volume, low pressure (HVLP) models are designed to reduce overspray and provide maximum transfer
efficiency by limiting air cap pressure to 0.7 bar (10 psi) (complies with rules issued by SCAQMD and other air
quality authorities).
HVLP models will produce approximately 0.7 bar (10 psi) air cap pressure at 1.6 bar (24 psi) gun inlet
pressure with the trigger pulled. HVLP air cap #HV30 is designed for optimum basecoat and clear coat
applications. An air cap test kit is available (see Accessories) which can be utilized to set the exact air cap
pressure.
High efficiency models use air cap #TE10 or #TE20. These models are designed to provide optimum
atomization of virtually all waterborne or solvent-based common coating materials at increased
application rates while maintaining very high transfer efficiency. High efficiency models, when tested under
recommended conditions with automotive refinishing materials, have been found to exceed 65% transfer
efficiency.
IMPORTANT: These guns are not designed for use with highly corrosive and/or abrasive materials and if
used with such materials it must be expected that the need for cleaning and/or replacement of parts will be
increased. If there is any doubt regarding the suitability of a specific material, contact your TEKNA Distributor
or TEKNA direct.
NOTE: This gun is not to be used with halogenated hydrocarbon solvents or cleaning agents such as
1,1,1,-Trichloroethane or methylene chloride. These solvents can react with the aluminium components
used in this gun and cup. The reaction can become violent and lead to an equipment explosion.
D Smith, General Manager
February 2014
TB-1020
3