Maintenance & Cleaning - INVENTOR MB490W Manuel D'utilisateur

9. MAINTENANCE & CLEANING
exterior, keep in mind the door must be shut to avoid getting any polish on the magnetic
door seal or the interior of the unit.
• Upon cleaning, rinse the interior with clean water and dry.
• Allow the appliance to dry for
approximately 1 to 2 hours.
• Set thermostat to middle position.
Plug into a power source. The
appliance will chill continuously until
set temperature has been reached.
• Frequently the air vents and the
condenser must be cleaned located
at the rear end of the appliance,
using a vacuum cleaner or a brush. The
condenser should always be clean, free of
dust or any other impurities.
EN
• Do not use abrasive products, abrasive cleaning pads,
solvents or metal objects. Do not use water spray and
steam to clean the appliance.
• Do not use extreme moist cleaning pads. Any moisture
around the electric components, should be avoided.
• The use of a steam cleaner is prohibited, as this may
be very dangerous.
Prior to cleaning the appliance, un-
plug from the wall power socket,
and remove all shelves.
• Clean the appliance with a
moist soft cloth. Use only neutral
detergents.
• Clean the unit's interior with a
weak bicarbonate soda solution
and rinse with warm water applying
a damp sponge or cloth.
• Use a damp cloth to clean the
Clean the
interior of
the appliance
ONCE A
MONTH
13