Maintenance Schedule; Problems And Solutions - HBM Machines 55019HBM Manuel D'utilisation

MAINTENANCE SCHEDULE

The maintenance operations described below can be performed by the user. You can also ask a qualified technician to perform these maintenance works.
Engine oil Check the oil level
Change oil
Air filter Check
Clean
Spark plug Clean or adjust
Replace
Fuel tank Check the fuel level
Drain
Carburettor Drain
Spark arrester Check / clean
Battery Shutdown
* Clean / replace more often in dusty conditions or with intensive use.

PROBLEMS AND SOLUTIONS

Problem
Machine does not start.
The motor has no power.
AC reset button not working.
16
Every 8 hours Every 25 hours
or daily
X
X
Cause
Battery is not charged.
The multi switch is set to "OFF"
No gasoline.
Stale gasoline or water in gasoline.
Oil level is low.
Fuel switch is set to "OFF".
Spark plug defective, dirty or incorrectly
spaced.
Engine stored without draining gasoline.
The air filter is dirty.
The air filter is dirty.
Engine stored without draining gasoline.
Output indicator is "OFF", and overload
indicator is "ON".
AC circuit protection has tripped.
GFCI system is activated.
The device that is connected is defective.
After 3 months After 6 months
or 50 hours or 100 hours
X
X*
X*
Solution
Replace the battery.
Rotate the Multi Switch to "ON".
Fill the fuel tank.
Replace the gasoline.
The machine shuts down when the oil level is low. Top up the oil level.
Turn the fuel switch to "ON".
Adjust or replace the spark plug.
Drain the fuel. Refuel the engine with new gasoline.
Clean or replace the air filter.
Clean or replace the air filter.
Drain the fuel. Refuel the engine with new gasoline.
Check AC load. Stop and restart the engine. Check the cooling air intake. Stop
and restart the engine.
Check the AC load and reset the AC circuit protector.
Reset the RCD.
Try another device.
For storage If necessary
X
X
X
X
X
X
X
X
X
X