rodac RC129 Mode D'emploi page 7

4.2 Supply by cartridge:
4.2.1
Every times needs the opening of the tank, is obbligatory to release the air contents, draw the ring of the dump valve(18) situated on the lid of the tank.
4.2.1 Unscrew the tank counterclockwise.
4.2.2 Insert the cartridge.
4.2.3 Screw on the cartridge clockwise.
4.2.4 Reposition the tank.
4.2.5 Screw on the tank clockwise.
4.2.6 The spray gun may be supplied by a cartridge, as above, or by pouring the loose product directly into the tank, making sure not to exceed the maximum
level of 1 lt.
4.3 Installing the KIT RC129 (optional):
4.3.1
4.3.1 Unscrew the cap ( n.6 ) counterclockwise from the cap holder (n.7) and remove it.
4.3.2 Select the extension most appropriate for the type of job to be carried out (n. 15/16/17) and install it on the cap holder.
4.3.3 Screw the extension to the cap clockwise and tighten
:
Advice
Loosen the cap holding ring n.1 and instead of rotating the extension, turn the cap holder clockwise, so that the extension screws onto the cap.
Afterwards, tighten the cap holder ring back to its original position
4.2.2
4.3.2
4.2.3
4.3.3
4.2.4
RC129 - English
4.2.5
7