Publicité
Les langues disponibles
Les langues disponibles
Power Supply:
The transmitter operates with either 8 dry batteries, 8 NiCad, NiMh cells or a recharge-
able battery pack with 9.6 Volt.
Converting the Throttle Stick:
According to your steering preference, the throttle function can be changed to a different
position. In order to do so do the following steps: (the pictured example showing stick con-
version from Mode 2 to Mode 3)
•
Remove the transmitter crystal and the battery box
•
Remove the 4 rear case transmitter screws
•
In order to remove the rear case you must remove the connectors to the potentio-
meters and the simulator jack (remove the threaded retaining nut on the top case).
Carefully remove the connectors, no wires may come loose.
•
Remove the spring of the right stick unit (Picture 2, left)
•
Un-tighten the 4 screws of the right stick unit a little for easier removal of the spring
lever arm (Picture 3).
•
Remove the spring lever arm and tighten the 4 screws again
•
Unscrew the ratchet on the left stick unit and hang up the lever arm and spring of the
right stick unit. The left stick lever is now self centering.
•
Tighten the ratchet at the right stick unit.
Picture 2
Tighten
ratchet
Remove
spring lever
arm
Remove
spring
•
At next exchange the connectors of both stick units. The two inner and outer
connectors need to be exchanged (See pictures on the following pages).
Hang up
spring
Insert spring
lever arm
Remove
rests
8
Picture 3: lever arm
Publicité
