Publicité
Les langues disponibles
Les langues disponibles
Stick Lever Length Adjustment:
In order to adjust the control stick length, twist the threaded control stick further in or out.
Trim Lever Adjustments:
You can fine adjust the center position of each function with the 4 trim levers. Initially bring
each trim lever to the center position (except throttle trim) and adjust during flight - if neces-
sary.
Information for using the transmitter:
This transmitter is a powerful and precise R/C transmitter. There are no parts to be maintai-
ned inside the radio. Do not open the case. Do not expose the radio to increased humidity
(moisture) and do not let the transmitter drop to floor. The transmitter must be used with
explicitly recommended crystals and receivers. Ask your local hobby shop before using ac-
cessories of other vendors.
Obey the safety rules when using RC transmitters and –receivers in order to protect people,
animals and property. When in doubt, ask your local hobby shop, model club or club mem-
ber.
Safety Notes
The CE badge is not a charter for the careless use of technical devices. Avoid danger areas
of motors, propellers, gears and rotors. Consider electrical systems as potentially dangerous.
Always remove the batteries when working on the model. Avoid humidity and condensation
humidity. The product is not polarity safe! Polarity or reversal of wires could result in unre-
pairable damages. Connectors must always match each other. Improvisations could result in
damages. Never separate an electric unit from the battery when still in use.
Operating Instructions
Always switch on the transmitter first and then the receiver unit. Ensure the throttle stick is in
the idle position. Check before flight that you are the only one using the transmitter frequency
and nobody else is using the same frequency. Take a look at the CE-badge of the other RC
components. For electrical noise suppression an motors use at least 2 ceramic capacitors
with 10-100 nF/63-100V and if necessary further noise reduction suppressing methods (Fil-
ter, throttle). Lead the antenna more than 3 cm (1.18 inch) away from motor, battery, cont-
roller and its wires. Install the receiver unit away from motor, controller and battery. Have the
wires as short as possible. Motor and battery cables should be "twisted".
When not using the model, remove the battery and store the model dry at normal air humidity.
Should you experience an unusual behavior of the model, disconnect the battery pack from
the system and reconnect after a waiting period of 5-10 seconds.
11
Publicité
