Installation Of The Configuration Software - Bausch Proxima ISDN Lite Manuel D'installation

Proxima ISDN Lite Installatiehandleiding
You now get a screen that allows you to choose the serial port the Bausch
Proxima ISDN Lite needs to be connected to. In general this is COM2.
Select the port and click Next.
After that, the final screen will appear: your modem has been set up
successfully. Click Finish.
If you want to install several protocols, you can do so by repeating the last
steps.
After this the installation is completed.
Remark: Windows implies you need a separate 'modem' for each protocol, but
actually one 'modem' (in this case the Bausch Proxima ISDN Lite) can handle all
these protocols.

3. Installation of the configuration software.

After the Plug & Play installation of the drivers in Windows 95/98 (chapter 2.1 en
2.2), the installation of the configuration software has started automatically. After
that the opening screen, as shown on top of the next page, will appear.
In case you are installing everything manually (chapter 2.3) in Windows, you can
install the configuration software by going to Start, Run and then type A:SETUP.
After that you click OK. The opening screen, which you can find at the top of the
next page, will appear. Then click Next.
Remark: before starting with the configuration, you should close all programs in
Windows. If you closed all programs, continue with the configuration (see above:
installing the configuration software after a manual installation of the drivers).
30/11/1999 Bausch Datacom
58