Bausch Proxima ISDN Lite Manuel D'installation page 55

Proxima ISDN Lite
Remark: In some versions of Windows 95 the automatic installation procedure can
be interrupted. In that case you will have to define the location of the disk drive
manually. Just type A:\
After that the installation will continue as planned.
The different 'modems' (one 'modem' for each possible ISDN B-channel protocol)
will now be installed automatically.
Proxima ISDN Lite V.120
Proxima ISDN Lite PPP
Proxima ISDN Lite V.110
Proxima ISDN Lite ML-V120
Proxima ISDN Lite ML-PPP
Windows implies you need a separate 'modem' for each protocol, but actually you
only need one (in this case, the Bausch Proxima ISDN Lite) which can handle all
these protocols.
You will have to reboot your computer upon completion of the installation. Make
sure you remove the driver disk from the disk drive. Then Reboot.
Remark: Some versions of Windows 95 will not show the above screen. In that
case you will have to reboot the computer yourself. To do so, go to Start,
Shutdown and then select Restart the computer.
If you succeeded in all the above steps, you can continue with Chapter 3,
'Installation of the configuration software'.
If you did not succeed in all the above steps, you can install the Bausch Proxima
ISDN Lite manually, as explained in Chapter 2.3, 'Manual installation in Windows
NT'.
30/11/1999
V.120 protocol – 64 Kbps
PPP protocol – 64 Kbps
V.110 protocol
multilinkV120protocol–128 Kbps
multilink PPP protocol–128 Kbps
55
Installatiehandleiding
Bausch Datacom