Description (Fig. A) - Ferm RSM1015 Traduction De La Notice Originale

- a saw blade that is not properly mounted;
- sawing into a previous cut;
- a lack of attention to the operation;
- an instable stance.
ELECTRICAL SAfETy
3
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
● Do not use the machine if the mains cable or
the mains plug is damaged.
● Only use extension cables that are suitable for
the power rating of the machine with a
minimum thickness of 1.5 mm
extension cable reel, always fully unroll the
cable.
Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approved BS 1363/5A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
TECHNICAL DATA
Mains voltage
Mains frequency
Power input
No-load speed
Max. sawing depth
Wood
Steel
Max. sawing stroke
Weight
. If you use a
2
RSM1015
V~ 230
Hz 50
W 600
min 0 - 2,500
-1
mm 115
mm 6
mm 20
kg 3.2
NOISE AND VIBRATION
Sound pressure (L )
pa
Acoustic power (L )
wa
Uncertainty (K)
Vibration
Uncertainty (K)
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardised test given in EN 60745; it may be used
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns

DESCRIPTION (fIG. A)

Your reciprocating saw has been designed for
sawing wood, metal and plastics.
1. On/off switch
2. Lock-off button
3. Release button for auxiliary grip
4. Saw blade holder
5. Saw shoe
6. Adjustment handle for saw shoe
7. Main grip
8. Auxiliary grip
9. Carbon brush holder
ASSEMBLy
3
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
RSM1015
dB(A) 82.4
dB(A) 93.4
dB(A) 3
m/s 11.8
2
m/s 1.5
2
5