Bushnell YARDAGE PRO Scout Manuel D'instructions page 4

Features
The YARDAGE PRO SCOUT's sophisticated digital technology allows you to select between various
units of measure and targeting modes. In addition, your YARDAGE PRO SCOUT's LCD incorporates
illuminated indicators that advise you when the laser is active and when the battery charge is low. A
summary of these features is presented below:
UNIT OF MEASURE OPTIONS
The YARDAGE PRO SCOUT can be used to measure distances in yards or meters. The unit of measure
indicators are located in the upper right portion of the LCD. To select between yards and meters, look
through the monocular, depress the "mode" button (left side of the unit underneath the BUSHNELL
YARDAGE PRO logo) and hold it down for approximately 2 seconds. If you are changing from yards
to meters, a change in unit of measure will be indicated by the illumination of the letter M for METER
indicator while the YD for YARD indicator is turned off. If you are changing from meters to yards, the
opposite will occur. Note: The YARDAGE PRO SCOUT will return to the last setting used, each time
the unit is turned on.
poWer Button
mode Button
4
YP SCOUT 6LIM.indd 6-7
monocular
BatterY
compartment
TARGETING MODES
The YARDAGE PRO SCOUT incorporates exclusive targeting modes that allow you to adjust the
performance parameters of the unit to suit your specific situation and environment. The different targeting
modes available are listed below:
Standard (LCD Indicator - none): This setting allows most targets to be distanced up to 570 yards. Used
for moderately reflective targets that are typical of most distancing situations. The minimum distance in
the standard mode is 10 yards.
SCAN (LCD Indicator - "SCAN"): When the Power button is held down longer than 3 seconds, the
unit transitions to SCAN mode. This mode allows the range to be continuously updated as long as the
Power button remains depressed. The word "SCAN" will blink and appear in the left side of the LCD
once this mode is activated.
>150 (LCD Indicator - ">150"): This mode can be used to ignore energy pulses reflecting off objects
less than 150 - 165 yards / meters away. It would typically be used when distancing through brush to an
object further than 150 yards / meters away. Note: In this mode, the system will not measure to targets
less than 150 yards / meters.
To select >150 Mode, while looking through the monocular, depress and release the mode button. Note:
The YARDAGE PRO SCOUT will return to the last setting used, each time the unit is turned-on.
IllumInatIng IndIcators
Low Battery Charge (LCD Indicator - ): When both dashes inside the battery symbol are displayed,
the battery is fully charged. When the dashes start to fade away, it means the battery charge is getting low
and the 3-volt lithium battery should be replaced.
5
9/6/05 11:34:15 AM