Kichler Motu 330010 Manuel D'instructions page 9

10. INSTALLING THE BOTTOM CAP
Step 1. Remove and save the two pre-attached
screws on the mounting ring attached to the
motor shaft. (Fig. 16)
Step 2. Push up the bottom cap to the mounting
ring and align the holes on the bottom cap and
mounting ring.
Step 3. Secure the bottom cap by installing the
two screws removed in the first step and tighten
them.
Step 4. Install the decorative nut by screwing it
into the shaft. (Fig. 17)
11. OPERATING INSTRUCTIONS
-
= Power Off
1 = High Speed
2 = Medium-High Speed
3 = Medium-Low Speed
4 = Low Speed
Screws
Fig. 16
Decorative nut
Fig. 17
12
KICHLER
Fig. 18
60" Motu
™
8
Bottom cap
4
3
2
1
-
R