Finishing The Installation - Kichler Motu 330010 Manuel D'instructions

7
Outlet box
Ceiling
mounting
bracket
Screw
Fig. 14
Screws
Fig. 15
Screw
Canopy
Canopy cover
Blade
Blade arm

8. FINISHING THE INSTALLATION

Step 1. Tuck all the connections neatly into the ceiling
outlet box.
Step 2. Slide the canopy up to the mounting bracket
and place one of the key hole slots over the mounting
screw on the mounting bracket. Rotate the canopy until
the screw head locks in place at the narrow section of
the key hole. (Fig. 14)
Step 3. Align the remaining circular hole on the canopy
with the remaining hole on the Ceiling Mounting
Bracket. Insert and tighten the mounting screw from
step 2 above. Now, attach the canopy cover to the
mounting screw head by inserting the screw heads into
the bottom side of the canopy cover and rotating the
cover clockwise.
NOTE:
Adjust the canopy screws as necessary until
the canopy and canopy cover are snug. (Fig. 14)
9. ATTACHING THE FAN BLADE/
BLADE ARM ASSEMBLIES
Attach each blade assembly to the motor by using
two mounting screws for each blade assembly.
(Fig. 15)
NOTE
: Make sure these mounting screws are
securely tightened.