Using The Headphones - AudioMX HG-11B Manuel De L'utilisateur

Operating Your Headphones
Powering the transmitter
Connect the supplied AC adaptor to DC inlet on the transmitter and plug the
adaptor into the electrical wall outlet. The transmitter's green indicator light will
flash for approximately five seconds, then switch to steady green, indicating that
the transmitter has established communication with the headphones.
Connecting the transmitter to audio sources
Use the audio cable to connect the transmitter's audio jack to the earphones
output connector on a TV, portable audio player or other audio playback device.
If the audio output of your playback device utilizes a 6.3 mm headphone jack, use
the furnished plug adapter.

Using the headphones

Turning on the headphones
1.Press the power button on the headphones.
2.To turn on the headphones, press and hold the power button. The power
indicator will turn green.
Connecting the transmitter and headphones
1.Place the headphones close to the transmitter; communication will be
established automatically between the transmitter and headphones.
2.When communication is established, the signal indicator light turns green and
7
a short sound is produced from the headphones.
Adjusting the volume
Use the Volume up/down buttons to adjust the sound volume. When the sound
volume is set to its maximum output value, a beep sound will be heard from the
headphones.
Standby mode (transmitter)
If no audio signal is input to the transmitter for five minutes, the transmitter
will automatically switch to standby mode (and the transmitter's power/charge
indicator will go out). When an audio signal is once again received by the
transmitter, the transmitter will exit standby mode automatically.
Auto power off (headphones)
When no signal is received from the transmitter, the headphones' signal indicator
will go out and no sound will be produced from the headphones. If this condition
continues for five minutes, the headphones power will automatically turn off.
Auto mute (headphones)
If the distance between the transmitter and headphones exceeds the allowable
transmission distance, the signal indicator will turn off and the headphones will
be muted automatically. To re- establish communications with the transmitter,
move the headphones closer to the transmitter.
8