Maintenance; Troubleshooting - Arctic Cove MBF0181 Manuel D'utilisation

WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
WARNING:
With the battery pack removed from the misting fan,
always clean and thoroughly dry out all parts of the
misting fan, intake tube, and buckets when not in use
to prevent the possible formation of bacteria or mold.
Spraying mist that contains bacterial or mold can result
in serious personal injury or illness.
PROBLEM
Leak at nozzle or threaded hole
Fan will not start

MAINTENANCE

TROUBLESHOOTING

POSSIBLE CAUSE
Nozzles were installed improperly.
Nozzles clogged or dirty.
Battery is defective or fully discharged.
This product has a one-year Limited Warranty.
For Warranty details go to www.arcticcove.com
NOZZLE MAINTENANCE
See Figure 7.
WARNING:
Ensure all nozzle maintenance is properly performed
to prevent leaks. Leaks can result in a slippery surface,
create a slip and fall hazard, or cause property damage.
Irregular mist patterns or leakage may be the result of a
clogged or dirty nozzle.
To clean nozzles:
 Make sure both the power switch and pump switch are
in the OFF ( O ) position.
 Remove the battery pack.
 Remove the brass nozzles from each side of the fan.
 Soak nozzles in Arctic Cove nozzle cleaner (MACC008,
not included) to loosen foreign materials clogging or
restricting the nozzle.
 Using a garden hose, flush debris out of nozzle by back
flushing (running the water through the nozzle backwards
or from the outside to the inside).
 Reconnect the nozzles.
FILTER MAINTENANCE
See Figure 8.
Periodically check the filter at the end of the intake tube for
debris and to make sure it is in good condition. Remove the
plastic filter cover and rinse or replace the filter, then snap
the cover back together.
SOLUTION
Reinstall nozzles and tighten securely.
Clean nozzles.
Charge battery or contact customer
service.
7 — English