Velux INTEGRA KLF 200 Manuel D'installation Et Mode D'emploi page 26

Function as repeater
Registration with VELUX INTEGRA® KLR 200
The repeater function extends the operation range
of two-way control pad KLR 200 by transmitting
received wireless commands. When used as a
repeater, KLF 200 is therefore to be placed ap-
proximately halfway between the control pad and
the io-homecontrol
Note: The repeater function cannot be used with
one-way wall switch KLI.
Registration with VELUX INTEGRA
KLF 200 is registered with control pad KLR 200 in
the same way as a new product is added.
Note: Up to three KLF 200 in a system can be set
to repeater function.
The operation range of the control pad cannot be
extended further in the same direction by placing
more repeaters after each other as commands can
be sent only via one repeater.
1
5 sec
26 VELUX
®
products to be operated.
®
KLR 200
®
Press the RESET button on
the back of KLF 200 for
5 seconds with a pointed
object until the diode emits
red light. Subsequently, the
diode flashes yellow.
ENGLISH