Electrolux EXP09CN1W5 Manuel D'utilisation page 11

6. To secure lower sash in place, attach
right angle sash lock with 1/2"
(12.7mm) screw as shown (FIG. 16).
NOTE: It is difficult to lock the
windows with the sash lock for Vinyl-
Clad windows, so you can use lock
by window itself.
7. Cut the foam seal to an appropriate
length and seal the open gap between
the top window sash and outer
window sash, as shown in Fig.17.
Fig. 16
Foam seal
Foam seal
Fig. 17
Installation in a sliding sash window
1. Cut the foam seals(adhesive type) to
the proper lengths and attach them
to the window frame. See Fig.18.
Foam seal
Foam seal A
(adhesive type)
(adhesive type)
Fig. 18
2. Open the window sash and place
the window slider kit on the window
stool. See Fig.19. Attach the window
slider kit to the window stool. Adjust
the length of the window slider kit
according to the height of window.
Screw down the two screws on the
window slider kit. See Fig.19. Cut
the adjustable window slider kit if the
height of window is less than 26.6
inches (Fig. 14).
Window stool
Window stool
Window slider kit Window slider kit
screws
screws
26.6"~48.5"
26.6"~48.5"
Fig. 19
3. Close the sliding sash securely
against the window slider kit. (Fig. 20)
4. Drive two 1/2" screws to secure
the window slider kit to the window
sash. (Fig. 20)
5. Drive two 3/4" screws to secure
the window slider kit to the window
stool. (Fig. 20)
Window stool
Window stool
3/4" screws
3/4" screws
Fig. 20
6. Cut the foam seal to an appropriate
length and seal the open gap
between the sliding sash and outer
window sash, as shown in Fig.21.
7. To secure the sliding sash in place,
attach right angle sash lock with
1/2"(12.7mm) screw as shown.(Fig.22)
Fig. 21
Fig. 22
ENGLISH 11
Window slider kit
Window slider kit
1/2" screws
1/2" screws
Foam seal
Foam seal