Intended Use; Additional Safety Warnings; Residual Risks - Dexter 20VRPS2-180.1 Mode D'emploi

1. INTENDED USE

It is suitable for straight cuts with the cutting angles keeps 90°
do this by the manufacturer of the product. Do not use the product for any other purpose.
The saw blade recommendations are to be observed.
2. SPECIFIC SAFETY WARNINGS
A. Hold the power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact
hidden wiring. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give
the operator an electric shock.
B.Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the workpiece by hand
or against your body leaves it unstable and may lead to loss of control.

3. ADDITIONAL SAFETY WARNINGS

A. Secure the workpiece. A workpiece clamped with clamping devices or in a vice is held more secure than by hand.
B. Do not work materials containing asbestos. Asbestos is considered carcinogenic.
C. Always wait until the tool has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over
the power tool.
D. Do not use a power tool with a damaged power cord. Do not touch the damaged cord and pull the power plug when the cord
is damaged while working. Damaged cords increase the risk of an electric shock.
E. Connect power tools that are used in the open via a ground fault circuit interrupter.
F. Keep hands away from the cutting area. Do not reach under the material being cut. Contact with the saw blade may result in injury.
G. Guide the tool against the workpiece only when it is switched on. Otherwise there may be danger of kickback when the tool insert jams
in the workpiece.
H. While sawing, pay attention that the pivoting saw shoe always faces against the work. The saw blade can become wedged and
lead to loss of control over the power tool.
avoids kickback and the tool can be placed down securely.
J. Use only undamaged blades that are in proper condition. Bent or dull saw blades can break or cause kickback.
K. Properly clamp the material th cut. Do not support the workpiece with your band or foot. Avoid touching any objects to the ground
with the running saw blade. Danger of kickback.
L. Use appropriate detectors to determine if utility lines are hidden in the work area or call the local utility company for
assistance.
causes property damage or may cause an electric shock.
break or cause kickback.
N. Hold the power tool only by the insulated gripping surfaces when performing an operation where the cutting tool may
contact hidden wiring of its own power cord. Contact with a " live"wire also makes exposed metal parts of the power tool "live" and shocks
the operator.

4. RESIDUAL RISKS

Even when the power tool is used as prescribed it is not possible to eliminate all residual risk factors. The following hazards may arise in
connection with the power tool's construction and design :
• Damage to health resulting from vibration emission if the power tool is being used over a longer period of time or not
adequately managed and properly maintained.
5. RISK REDUCTION
It has been reported that vibrations from handheld tools may contribute to a condition called Raynaud's Syndrome in certain individuals.
exposure to cold and dampness, diet, smoking, and work practices are all thought to contribute to the development of these symptoms. There are
• Keep your body warm in cold weather. When operating the product, wear gloves to keep the hands and wrists warm. It is
reported the cold weather is a major factor contributing to Raynaud's Syndrome.
• After each period of operation, exercise to increase blood circulation.
• Take frequent work breaks. Limit the amount of exposure per day.
71
ven about how to
This
ine
The saw blade can become damaged,
y factors,
FR
ES
PT
IT
EL
PL
UA
RO
EN