Greenlee TG-1000 Manuel D'instructions page 5

Important Safety Information
• Temperature readings will be inaccurate on highly reflective objects.
• Temperature readings will be inaccurate on objects if emissivity is not adjusted properly.
Follow masking and emissivity adjustment procedures.
• Allow 30 minutes for the unit to adjust to large changes in ambient temperature;
inaccurate readings can result.
• Clean lens periodically; inaccurate readings can result. Refer to the "Maintenance" section.
Failure to observe these precautions may result in injury and can damage the unit.
• Using this unit near equipment that generates electromagnetic interference can result in unstable
or inaccurate readings.
• Protect the unit against static electricity.
CE Certification
This instrument conforms to the following standards:
• EN50081-1:1992, Electromagnetic Emissions
• EN50082-1:1992, Electromagnetic Susceptibility
Readings may be affected if the unit is operated with a radio frequency electromagnetic field of
approximately 3 volts per meter, but the performance of the instrument will not be permanently
affected.
CFR 21 1040.10 and 1040.11
Performance Standards for Light-Emitting Products
TG-1000
5