Airwell AW-CFV07-N11 Manuel D'installation Et D'opération page 20

Electrical Wiring
Dipswitch Setting
Indoor Units PCB
In the following table, 1 represents ON and 0 represents OFF.
Definition principles of code switches:
SWO1 is used to set capabilities of master and slave indoor units as well as indoor unit; SW03 is used to set indoor unit
address (combine original communication address and address of centralized controller).
(A) Definition and description of SW01
SW01_1
SW01_2 Address of wire
SW01_3 controlled indoor unit
SW01_4
SW01_5
SW01_6
Capability of indoor unit
SW01_7
SW01_8
[1] [2] [3] [4]
0 0 0 0
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 0
0 1 0 1
∙∙∙ ∙∙∙ ∙∙∙ ∙∙∙
1 1 1 1
[5] [6] [7] [8]
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 1
0 1 1 0
0 1 1 1
1 0 0 0
1 0 0 1
1 0 1 0
1 0 1 1
1 1 0 0
17
Address of wire controlled indoor unit (group address)
0# (wire controlled master unit) (default)
1# (wire controlled slave unit)
2# (wire controlled slave unit)
3# (wire controlled slave unit)
4# (wire controlled slave unit)
5# (wire controlled slave unit)
15# (wire controlled slave unit)
Capability of indoor unit
0.8HP (AW-CFV09/07-N11)
1.0HP (AW-CFV09/07-N11)
1.2HP (AWSI-CFV012-N11)
1.7HP (AW-CFV018/016-N11)
2.0HP (AW-CFV018/016-N11)
2.5HP (AWSI-CFV024-N11)
3.0HP (28K)
3.2HP (AW-CFV038/030-N11)
4.0HP (AW-CFV038/030-N11)
5.0HP (
6.0HP (
∙∙∙
AW-CFV060/048-N11 )
AW-CFV060/048-N11 )