Specifications - AKG SR40 FLEXX Mode D'emploi

BDA SR 40 FLEXX_2008_Hex:Layout 1
5 Troubleshooting
Problem
Momentary loss of sound
("dropouts") at some locations
within performance area.

6 Specifications

Receiving frequency
Modulation
Audio bandwidth
T.H.D. at 1 kHz
Compander
Signal/noise ratio
Current consumption
Power requirement
Squelch threshold
Audio output
Size
Net weight
This product conforms to the standards listed in the Declaration of Conformity. To order a free copy of the Declaration of Con-
formity, visit http://www.akg.com or contact sales@akg.com.
20
01/21/2008 10:32
Possible Cause
2. Interference from other wireless
systems, TV, radio, CB radios, or
defective electrical appliances or
installations.
• Antenna location.
660 to 865 MHz
FM
35 Hz to 20 kHz
typ. 0.8%
Yes
typ. 110 dB(A)
115 mA/12 V
120/230 VAC, 50/60 Hz
-100 dBm to -70 dBm, adjustable
bal. XLR and unbal. 1/4" jack: adjustable from mic to line level.
Output level at rated deviation: 500 mV rms
200 x 190 x 44 mm (7.8 x 7.4 x 1.7 in.)
665 g (1.5 lbs.)
Seite 20 (Schwarz/Black Auszug)
Remedy
2. Switch off interference sources or
defective appliances; switch trans-
mitter and receiver to different fre-
quency / use transmitter and
receiver operating in a different fre-
quency band; have electrical instal-
lation checked.
• Relocate receiver. If dead spots
persist, mark and avoid them.
SR 40 FLEXX