Hog Slat Grower Select HS583E Mode D'emploi page 21

Ventilation Systems
INSTALLATION OF HS583-100 SIDE COVERS
1. Determine how cables/chains will exit the machine.
a. If the cables/chains exit on each side of the machine, cut off the lower rectangular
protrusion on each side cover using a hack saw, reciprocating saw or similar tool. This
will reveal a rectangular opening for the cable/chain to exit. See Figure 2&3
b. If both cables/chains exit on the same side then cut both protrusions on (1) side cover
only. The untouched side cover will be used to cover up the non-used side of the
machine. See Figure 4
Hog Slat Inc. Newton Grove, NC USA May 2019
Figure 1
Figure 3
Figure 2
Saw Blade
Figure 4
REV A10
21