Hog Slat Grower Select HS583E Mode D'emploi page 14

Ventilation Systems
9. If mounting machine horizontally in order to pull cables straight from end of machine, remove (2)
plastic plugs found at top of machine to access pre-punch holes for routing cables. Loop cable
around bearing supported pulley to ensure even load distribution on load block. Use 3 ½"
diameter V-groove pulley to maintain proper cable spacing. (Figure 17)
FOR INDOOR USE ONLY.
10. To secure cable to load block, run cable through hole nearest the center in load block, then loop
back up through the outboard hole. Tighten all set-screws. (Figure 18)
SET SCREWS
Hog Slat Inc. Newton Grove, NC USA May 2019
Figure 17
Figure 18
REV A10
SET SCREWS
14