Shutting Down - DeWalt DXPWH3040 Guide D'utilisation

WARNING: Risk of unsafe operation. If engine does not start after
two pulls, squeeze trigger of gun to relieve pump pressure. Pull starter
cord (K) slowly until resistance is felt. Then pull cord rapidly to avoid
kickback and prevent hand or arm injury.
note: If the oil level in the engine is low, the engine will not start. If
the engine does not start, check the oil level and add oil as needed.
12. If hot water cleaning is desired, place the burner On/Off switch (D)
in the on position.
WARNING: Burner will ignite and the green light will illuminate when
the trigger is depressed. DO NOT use the pressure washer if burner
fails to ignite.
WARNING: Risk of burns. The surfaces around the burner exhaust
and the discharged exhaust are very hot. Keep away from this area.
DO NOT allow hoses to come in contact with the very hot burner
exhaust area.
WARNING: Burner will shut off when the trigger is released. DO
NOT use the pressure washer if the burner fails to shut off.
13. Depress trigger on gun to start water flow.
WARNING: Risk of unsafe operation. Stand on a stable surface
and grip gun/wand firmly with both hands. Expect the gun to kickback
when triggered.
14. Release trigger to stop water flow.
DANGER: Risk of injury from spray. Engage the
trigger lock (Q) when gun is not in use to prevent
accidental spraying.
15. Adjust spray for the task being performed by
changing quick connect nozzle. Refer to spray
Wand nozzles.

Shutting Down

1. Place the burner on/off switch (D) in the off position.
2. Depress trigger on gun and allow water to run until the spray wand
is no longer hot to the touch.
3. If chemicals were applied, place the chemical hose into a container
of clean water and draw clean water through chemical injection
system to rinse system thoroughly.
NOTICE: Risk of property damage. Failure to rinse the chemical
system can cause damage to the high-pressure pump or the high-
pressure water system.
4. Turn engine off. Refer to the engine instruction manual for correct
procedure.
NOTICE: Risk of property damage. NEvER turn water supply off while
pressure washer engine is running or damage to pump will result.
5. Turn water source off.
6. Pull trigger on spray gun to relieve any water pressure in hose or
spray gun.
7. Refer to Storage for proper storage procedures.
MAINtENANcE
WARNING: Risk of burning. When performing maintenance, you
may be exposed to hot surfaces, water pressure or moving parts that
can cause serious injury or death.
WARNING: Risk of fire. Always disconnect, spark plug wire, let
Q
the engine cool and release all water pressure before performing any
maintenance or repair. The engine contains flammable fuel. Do not
smoke or work near open flames while performing maintenance.
To ensure efficient operation and longer life of your pressure washer,
a routine maintenance schedule should be prepared and followed.
If the pressure washer is used in unusual conditions, such as high
temperatures or dusty conditions, more fre quent maintenance checks
will be required.
13