DeWalt DXPWH3040 Guide D'utilisation page 12

• Never op e r a te unit in or near a lo c a t ion occupied by humans or
animals.
WARNING: Risk of fire, asphyxiation and burning. Never fill fuel tank
when engine is running or hot. Do not smoke when filling fuel tank.
• Never fill fuel tank completely. Fill tank to 1/2" (12.7 mm) below
bottom of filler neck to provide space for fuel expansion. Wipe
any fuel spillage from engine and equipment before starting
engine.
• DO NOT let hoses come in contact with very hot engine muffler
during or immediately after use of your pressure washer.
Damage to hoses from contact with hot engine surfaces will
NOT be covered by warranty.
NOTICE: Never pull water supply hose to move pres s ure washer. This
could damage hose and/or pump inlet.
• DO NOT use hot water, use cold water only.
• Never turn water supply off while pressure washer engine is
running or damage to pump will result.
• DO NOT stop spraying water for more than two
minutes at a time. Pump operates in bypass
mode when spray gun trigger is not pressed.
When the temperature inside the pump rises
too high the thermal relief valve (O) will open
and release a gush of water in an effort to lower
the temperature inside the pump. The thermal
relief valve will then close. If pump is left in bypass mode for
more than two minutes internal components of the pump can
be damaged.
start-uP ProceDure (FIG. 1)
1. In a well-ventilated outdoor area, add fresh, high-quality, unleaded
gasoline with a pump octane rating of 86 or higher. Do not overfill.
Wipe up spilled fuel before starting the engine. Refer to engine
instruction manual for correct procedure.
2. Check engine oil level. Refer to the engine instruction manual for
correct procedure.
3. In a well-ventilated outdoor area, add fresh, high-quality Number 1
heating oil (kerosene) or Number 2 heating oil (diesel fuel) to the
burner fuel tank fill (G). Do not overfill.
4. Connect the water hose to the cold water source. Turn the water
source on to remove all air from the hose. When a steady stream of
water is present, turn the water source off.
5. Verify the filter screen (P) is in water inlet of pump.
The cone side faces out.
6. Connect the cold water source to pump inlet (H).
note: Water source must provide a minimum of 5
gallons per minute at 20 psi (138 kPa).
note: Use a 5/8" (15.9 mm) or 3/4" (19.0 mm)
water hose of minimal length.
WARNING: To reduce the possibility of contamination always
protect against backflow when connected to a potable water system.
7. Connect high-pressure hose to high-pressure hot water outlet (L).
8. If applying a chemical or cleaning solution, refer to chemicals and
cleaning solvents.
O
9. Turn the water source on.
NOTICE: Risk of property damage. Failure to do so could cause
damage to the pump.
10. Remove all air from the pump and high pressure hose by depressing
trigger until a steady stream of water is present.
11. Start engine. Refer to the engine instruction manual for correct
procedure.
12
P