Rules For Safe And Effective Operation; Adjusting The Height Of Cut - Canadiana 7800903 Mode D'emploi

4. Stand behind the mower. Use one hand to hold the
engine stop lever (A, Figure 16) in the operating posi-
tion. Use the other hand to hold the recoil starter handle
(B).
5. Slowly pull the recoil starter handle until resistance is
felt, then pull quickly to start the engine. Slowly return
the recoil starter handle.
6. If the engine does not start in 5 or 6 tries, see the
Troubleshooting section.
Figure 16: Starting the engine

Rules for Safe and Effective Operation

Refer to the 'Operator Safety' section of this manual for
important rules concerning safe and effective mower
operation.
en
A
B

Adjusting the Height of Cut

WARNING: The blade will rotate when the
engine runs. Before you change the height of
cut, stop the engine and disconnect the wire
from the spark plug.
To change the height of cut, move the position of the
adjuster arm at each wheel (A, Figure 17). Make sure each
adjuster arm is in the same position so that the mower will
cut level.
1. Disengage the adjuster arm.
2. Move the adjuster arm to another position.
Figure 17: Adjusting the height of cut
Operation
A
15