Grass Bag - Canadiana 7800903 Mode D'emploi

Assembly
Assembling the Grass Bag (C22550FC)
Note: On some models, the side mounted discharge deflector
is temporarily attached (for shipping purposes) to the rear of
the mower. Before assembly of the grass bag, remove the
side mounted discharge deflector.
1. Slide the frame assembly (A, Figure 7) into the
grass bag (B).
2. Make sure the handle (A, Figure 8) is on the outside of
the grass bag.
3. First, attach the clips (B, Figure 8) to the side of the
frame assembly (C). Next, attach the clips to the top and
bottom of the frame assembly.
Mounting the Grass Bag (C22550FC)
1. To mount the grass bag on the mower, raise the rear
door (A, Figure 9). Holding the grass bag by the
dle (B), mount the hooks (C) on either end of the grass
bag frame assembly onto the rear door pivot rod (D).
Lower the grass bag against the rear of the mower.
Lower the rear door.
Important: Make sure both grass bag hooks are mounted on
the pivot rod.
WARNING: Check the condition of the grass
bag for wear or deterioration. If worn or
damaged, replace the parts only with
approved factory replacement parts.
Emptying the Grass Bag (C22550FC)
WARNING: Before you remove the grass bag,
stop the engine. Before you remove any grass
from the mower housing, disconnect the wire
from the spark plug.
1. Raise the rear door to a vertical position.
2. Hold the handle of the grass bag and lift the frame
assembly. Continue to lift the frame assembly until the
hooks are no longer mounted on the pivot rod. Remove
the grass bag.
3. Empty the grass from the grass bag.
4. To mount the grass bag on the mower, see "Mounting
The Grass Bag".
10
Figure 7: Installing the frame assembly
A
han-
Figure 8: Installing the bag clips
C
Figure 9: Mounting the grass bag
B
A
C
B
D
B
www.canadianaproducts.ca
A