Tectro TD 210 Manuel D'utilisation page 55

Fig. 3
man_TD210 ('11).indd 55
• Always remove the plug from the electric power supply before cleaning or replacing
the unit or components of the unit.
• Never use an extension cable to connect the device to the electric power supply. If
there is no suitable, earthed wall socket available, have one installed by a recognised
electrician.
• Children should be supervised to ensure that they do not play with the appliance.
• Have any repairs only carried out by a recognised service engineer or your supplier.
Follow the instructions for use and maintenance as indicated in the user manual of
this device.
• Always remove the plug of the unit from the wall socket when it is not in use.
• A damaged power cord or plug must always be replaced by a recognised electrician
or your supplier.
G
atteNtioN!
• Never use the device with a damaged power cord, plug, cabinet or control
panel. Never trap the power cord or allow it to come into contact with sharp
edges.
• Failing to follow the instructions may lead to nullification of the guarantee on
this device.
• Do not place the dehumidifier in bathrooms or in other places where it is
likely that water could be sprayed on the dehumidifier.
coNtrol liGHtS oN tHe coNtrol paNel
On / off button. Press to switch the device on or off.
This light indicates that the water container is full. The device switches off
automatically.
The device is in operation when this light is on.
operation
Insert the plug into the wall outlet and ensure that the water container has been
positioned correctly. If only the bucket full light
container from the device and replace it in the correct position. If both the lights, power
on and bucket full , switch on when inserting the plug into the wall outlet, and
extinguish after two seconds the dehumidifier can be started by pressing the power on
button. The power on indicator light switches on and the device starts to dehumidify.
Fig. 4
switches on, remove the water
4
55
27-04-11 16:03