Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Start-up / Cleaning and care
Start-up
Note: The heating pad may smell of plastic the first
time you use it, but this will disappear after a short
period of time.
To begin, first connect the control
heating pad with the plug-in connector
(see fig. B).
Position the heating pad according to your
individual requirements on your back or stomach
(see fig. C).
Wind the long, extendible rubber band around
your body.
Then fix the heating pad to your body by con-
necting the hook-and-loop fasteners of the heat-
ing pad with the hook-and-loop fasteners of the
rubber band (see fig. D).
Switching on / off / Selecting
the temperature
Switching on:
Set the control unit
switch on the heating pad.
Note: The function display
the heating pad is switched on.
Note: This heating pad features rapid heating,
which allows it to heat up within the first 10 mi-
nutes of operation.
Switching off:
Set the control unit
heating pad.
Note: The operating display
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
When using the heating pad for several hours, set
it to the lowest temperature setting (setting 1).
20 GB/IE
to the
1
3
to 1, 2, 3, 4, 5 or 6, to
1
illuminates after
2
to 0 to switch off the
1
will switch off.
2
ting the heating pad for several hours,
we commend setting the control unit
to the lowest setting to prevent over-
heating and potential burns to the
part of the body heat is applied to.
Temperature levels
Set the required temperature level on the
control
(see fig. A).
1
Level 0:
off
Level 1:
minimum heat
Level 2–5: customised heat
Level 6:
maximum heat
Automatic switch-off
Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function display
then starts to flash.
Then select the setting 0 and after about 5
seconds, reset the heating pad to the desired
temperature setting to switch it on again.
If the heating pad is no longer used after
the timer expires:
– switch off the heating pad (Setting 0),
– unplug from the socket,
– disconnect the plug-in connection
control unit
, from the heating pad.
1
Cleaning and care
LIFE BY ELECTRIC SHOCK! Always
remove the mains plug from the socket
and the plug-in connector
from the heating pad (see fig. B) before cleaning
the heating pad. Otherwise there is a risk of
electric shock.
When opera-
2
, i.e. the
3
DANGER TO
with the control
3
1
Publicité
Chapitres
Table des Matières
