Bosch GDE18V-26D Consignes D'utilisation/De Sécurité page 11

2610051575.qxp_GDE18V-16D 8/29/18 2:30 PM Page 11
Never use
attachment without a filter. If the dust
extraction attachment is used without a
filter, larger particles of drilling dust can
be flung towards the user and the
power tool can be damaged.
Only use an undamaged filter (no
cracks, small holes, etc.). Replace a
damaged filter immediately.
Never carry the power tool by the dust
extraction attachment.
Note: The guide 4 is spring-loaded. The
guide can spring forward when the
button 6 for drill bit length adjustment
is pressed (Fig. 1).
▶ Turning On and Off
To turn on the dust collector, press the
On/Off pushbutton switch 8.
To turn off the dust collector, press the
On/Off pushbutton switch 8 again
(Fig. 1).
▼ BATTERy CHARGE LEVEL
INDICATOR
After turning the unit on, the five green
LEDs 9 will indicate the charging level of
the battery 15 (Fig. 1).
▶ Inserting/Removing Drill Bits
(Fig. 4)
- Press and hold the button
guide all the way outward.
4
- Release the button
- Slide the tip of the drill bit through the
intake dust ring 3
then fit the bit into the chuck according to
the instructions of your power tool (B).
- Before removing the drill bit, press the
button again and pull the guide
6
way outward.
▶ Adjusting the Guide Length
(Fig. 5)
To ensure that dust is extracted cleanly
and the depth stop is set correctly, the
guide 4 must be adjusted so that the tip
of the drill bit is flush at the front with
the intake dust ring 3.
Operating instructions
the dust extraction
and pull the
6
.
6
from behind ( ) and
all the
4
Fig. 4
3
A
B
4
- Press and hold (A) the button 6 and
move (B) the guide 4 until the tip of
the drill bit is flush with the
"crosshair" of the intake dust ring 3.
- Release the button 6.
Note: To store the dust extraction
attachment, press the button 6 and pull
the guide 4 all the way outward. This
relieves strain on the guide's spring,
which increases the lifetime of the
spring.
3
3
3
3
6
Fig. 5
B
A
4 6
11