Installing The Battery - Facom 720.P1500 Notice D'instructions

To reduce the risk of injury, read and understand these
safety warnings and instructions before using the
tool. Keep these instructions with the tool for future
reference. If you have any questions, contact your FACOM
INTRODUCTION
The AC/DC Current Probe is based on Hall Effect technology and is
designed for use with multimeter for ac and dc current measurements.
Today's sophisticated electrical systems in electric vehicles, hybrid
electric vehicles and fuel cell vehicles have the Integrated Starter
Generator system or the Integrated Starter Alternator system that may
need this Current Probe to measure starting currents or alternator
currents up to 1500A peak.
This Current Probe is compatible with any instrument capable of
4000-count DC/AC millivolt measurements.

INSTALLING THE BATTERY

To avoid electrical shock, unclamp the Current Probe from any
conductor and disconnect the multimeter before installing or replacing
1. Set the range switch in OFF position to turn off the Current Probe.
2. Remove the screw on the battery cover and remove the battery cover.
3. Connect the battery ( 9V, 6F22 or equivalent ) to the battery connector,
make sure that the polarity connection is correct. Place the battery in
the battery compartment.
4. Reinstall the battery cover and the screw.
NU-720.P1500_0617 Vbeijing.indd 9
representative or distributor.
WARNING
the battery.
EN
9
04/07/2017 14:04:57