General Safety Precautions; Declaration Of Incorporation Of Partly Completed Machinery - entrematic Ditec PWR25H Traduction Des Instructions D'origine

1. General safety precautions

This installation manual is intended for qualified personnel only.
Installation, electrical connections and adjustments must be performed in ac-
cordance with Good Working Methods and in compliance with the present standards.
Read the instructions carefully before installing the product.
Incorrect installation could be dangerous.
Before installing the product, make sure it is in perfect condition.
Before installing the motorisation device, make all the necessary structural modifi-
cations to create safety clearance and to guard or isolate all the crushing, shearing,
trapping and general hazardous areas.
Make sure the existing structure is up to standard in terms of strength and stability.
The motorisation device manufacturer is not responsible for failure to observe Good
Working Methods when building the frames to be motorised, or for any deformations
during use.
The safety devices (photocells, safety edges, emergency stops, etc.) must be installed
taking into account the applicable laws and directives, Good Working Methods, installa-
tion premises, system operating logic and the forces developed by the motorized gate.
The safety devices must protect the crushing, shearing, trapping and general hazardous
areas of the motorised door.
Display the signs required by law to identify hazardous areas.
Each installation must bear a visible indication of the data identifying the motor-
ized gate.
When requested, connect the motorized gate to an effective earthing system that
complies with current safety standards.
During installation, maintenance and repair operations, cut off the power supply before
opening the cover to access the electrical parts.
The automation protection casing must be removed by qualified personnel only.
The manufacturer of the motorisation device declines all responsibility if compo-
nent parts not compatible with safe and correct operation are fitted.
Only use original spare parts when repairing or replacing products.
The installer must supply all information on the automatic, manual and emergency op-
eration of the motorised gate, and must provide the user with the operating instructions.
2. Declaration
completed machinery
EC Declaration of Conformity – Entrematic Group AB, declares that this product complies with
the essential requirements and other relevant provisions of Directive 2006/42/EC, 2014/30/EU.
A certified copy of the original Declaration of Conformity is available upon request via email:
technical-assistance.ditec@entrematic.com, clearly indicating the product code.
of incorporation
25
of partly