Charging Your Goal Zero Yeti; Charging From The Wall - GOAL ZERO YETI 1500X Mode D'emploi

Charging Your Goal Zero Yeti

CHARGE ME NOW: Before using or storing, plug your Goal Zero Yeti into the wall until it
is fully charged. Keep your Goal Zero Yeti plugged in when not in use to ensure it is always
ready. This will NOT cause harm to your battery. For more tips and tricks on keeping your
battery healthy, see the BATTERIES 101 section.
When charging your Goal Zero Yeti, you will notice a battery segment blinking in the
display. This indicates the current charge status. Once your Goal Zero Yeti is fully
charged, all battery segments will be lit and remain solid. As long as there is more power
going into the Goal Zero Yeti than is being pulled from the output ports, the display will
also indicate the time until fully charged. This is an estimated time based on the power
input and output numbers at that moment; it will gradually adjust to a shorter or longer
time as the average charge or discharge rates fluctuate.

Charging from the Wall

Using the included 120W AC Wall Charger, plug your Goal Zero Yeti into any wall outlet.
You will know the Goal Zero Yeti is charging when the blue LED light next to the INPUT
port turns on, and battery segments in the BATTERY DISPLAY are blinking. The Goal
Zero Yeti is fully charged when all battery segments stop blinking and remain solid. The
Goal Zero Yeti should recharge from the wall in about 13 hours.
1. The AC wall adapter comes in two pieces. Connect the two pieces by plugging the
cable into the box.
2. The 120W AC Wall Charger with the 8mm DC barrel connector can be plugged into
the the front of the Yeti or under the lid.
3. You can only use one wall charger at a time. If you want to charge your Yeti faster, call
our solutions center or look at our fast charge options on goalzero.com.
NOTE: To charge from your 12V output in your vehicle, use our 12V Car Charging
Cable SKU 98079.
5