Charging From Solar - GOAL ZERO YETI 1500X Mode D'emploi

Charging from Solar

IMPORTANT NOTE: When solar recharging your Goal Zero Yeti, take note of the
voltages of the solar panels and do not exceed 50V. Individual solar panels, or
solar panels chained in series in excess of 50V cannot be used with the Goal
Zero Yeti and can cause serious damage to the unit. For help on chaining solar
panels, call our Customer Solutions Center at 888-794-6250.
There are three different inputs you can use when charging your Goal Zero Yeti from
solar, two of which are located in the "INPUT" area on the left side of the Goal Zero Yeti
faceplate and a third one located inside the storage compartment under the top lid. One
of the front ports and the port inside the storage compartment are round 8mm ports
designed to be used with Goal Zero Solar Panels or wall charger. Each 8mm input port
can handle up to 120W. The Anderson Power Pole port is designed to be used with larger
or higher power solar panels and can handle 600W of power, which is the total capacity
for power across all input ports.
1. Place your solar panel where it will get as much direct sunlight as possible.
2. Insert the blue-ringed solar panel plug into one of the INPUT ports, either on the front
of the Goal Zero Yeti or in the storage compartment under the top lid. You will know the
Goal Zero Yeti is charging when the blue LED light next to the INPUT port lights up, and
the battery segments in the BATTERY DISPLAY are blinking. The Goal Zero Yeti is fully
charged when all battery segments stop blinking and remain solid.
3. You can also connect the Goal Zero Yeti to solar panels using the Anderson Power-
Pole port and the appropriate adapter (if necessary), next to the 8mm charging port.
4. You can chain multiple Goal Zero Solar Panels together to reduce solar recharge times.
Your Goal Zero Yeti is capable of taking in 120W of input through the 8mm ports and no
more than 600W of solar through the APP port.
6