Location And Clearances; Important; Ventilation Openings - Napoleon NZ6000 Instructions D'installation Et D'utilisation

10
3.1

LOCATION AND CLEARANCES

DO NOT INSTALL INTO ANY AREA HAVING A HEIGHT LESS THAN 7 FEET (CEILING OF ENCLOSURE TO
The appliance is shipped with a set-up face that is 1/8" larger on the
top, bottom and each side than the faceplate. Leave the set-up face in
place to act as a template when installing the fi nishing face.

IMPORTANT

This appliance, fully dressed, weighs 850 lbs (385.6kg). Ensure
there is adequate fl oor support for the appliance, chimney and facing
material. Some material could weigh thousands of pounds.
We recommend that the appliance be secured to the fl oor in
all cases.
Using the door opening as a datum, level the appliance by
shimming underneath the appliance. Remove and discard the
lifting handles. Bend the tabs down and secure the appliance to
the fl oor.

3.1.1 VENTILATION OPENINGS

The appliance enclosure must be provided with suffi cient air circulation to avoid a fi re hazard. Install ventilation
grilles (minimum openings of 40 sq. inches) at both fl oor and ceiling levels of the enclosure. These grilles must
not restrict the fl ow of heat by more than 25%. Do not install into any area having a height less than 7 feet
(ceiling of enclosure to appliance bottom, excluding hearth height). The location of windows, doors and the
traffi c fl ow in the room where the stove is to be located should be considered. If possible, you should choose a
location where the chimney will pass through the house without cutting a fl oor or roof joist.
W415-0594 / E / 10.19.12
APPLIANCE BOTTOM, EXCLUDING HEARTH HEIGHT).
:
IN G
R N
E R N L Y
W A
O W N O
B L
T IO N T:
E C M E
N N L A
S E
C O T IS D E
IO N
E R IE
A V E X E R
: N N F L T
IN G IR U F E N
N A C O
R N S O E M
W A T IO U L
U S S E
M B L Y
C O O N
N T:
M E
T
S E A N
T IS U R
E R M B T
A V C O E N
E M
A IR U L
S E