Warranty And Liability - Ega Master 79919 Manuel D'instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

The following table shows possible problems and their causes:

Problem, cause, remedy

Problem

Machine does not start

Machine keeps on

running after releasing

the safety lever control

Low speed

Speed too high

Hydraulic fluid leaking

Other problems

We ask you to send the machine to the supplier, if necessary.

To guarantee the performance of the machine it is necessary to compensate the

pressure under water. For every 10 meters of depth it is necessary to add one bar

pressure to the compressor with respect to the indicated.

Unless otherwise specified, our "General Sales Terms" apply. Warranty and liability claims in

regards to persons or equipment damages are invalid, if one or more of the following causes

apply:

• Improper use of the machine,

• improper assembly, startup, operation or maintenance of the machine,

• operation of the machine with defect safety devices or improperly fixed or non-functioning safety and

protection devices,

• not considering of the instructions in the operating instruction booklet concerning transport, storage,

assembly, startup, operation, maintenance and setting up of the machine,

• independent structural alterations or settings on the machine beyond the intended purpose,

• inadequate supervision of wear parts,

• improperly carried out repairs, inspections or maintenance,

• catastrophic cases due to foreign objects, acts of god or other reasons which are beyond our control.

TROUBLESHOOTING

Cause

Not connected to hydraulic

supply.

Defective hydraulic hoses or

quick couplings

Hydraulic hoses inverted

Too little operating pressure

Too small hose diameter

Too little volume flow

Too high back pressure

Too high operating pressure

Too high volume flow

Wrong hydraulic fluid

Damaged sealings